Your estimate · Ben Bolt, TX
An electrician (panel & service upgrade) job in Ben Bolt ≈ 150 A service · $300–$5,500 per project
That range is the per project for electrician (panel & service upgrade) in the Coastal Bend — a low–high band, not a single fixed price. Adjust the numbers below to match your job.
Paste it into a group chat or a neighborhood post — whoever opens it sees this same estimate.
Calculator
Electrician (Panel & Service Upgrade) Cost Calculator — Ben Bolt
NEC 220.82 optional method for single-family dwellings. Computes recommended main service amperage based on square footage and major appliances.
Excludes garage, unfinished basement, open porches.
NEC requires min 2 for kitchen + dining.
Use the cooling tonnage; CC heating is small.
Estimate
150 A service
Calculated demand: 107 A at 240 V. Recommended panel: 150 A (NEC 220.82 + 25% safety margin). Subtotal load 22.9 kVA; after demand factor and HVAC: 25.7 kVA.
- Calculated demand:
- 107 A
- Recommended panel:
- 150 A
- Subtotal (pre-demand):
- 22,900 VA
- HVAC contribution:
- 10,500 VA
Estimate per NEC 220.82 optional dwelling method (2023 cycle). Always confirm with a Texas-licensed electrician. Actual sizing depends on continuous-load duty cycles, future EV-charging plans, heat-pump strip-heater backup (matters for Zone 2A homes), and AHJ amendments. CC permits often require AHJ load-calc submittal before service upgrade.
Get an exact electrician (panel & service upgrade) quote
An estimate plans the job; a local pro prices it. See electrician (panel & service upgrade) in Ben Bolt to reach one.
Same estimate, nearby cities